Skip to content
Terrabindz — Shaping the Earth

Soil Nailing

Soil Nailing vs. Ground Anchors: Which One Should You Use?

By Terrabindz engineering team · · 5 min read

Both systems hold back excavations and slopes, but they work in different ways. Compare behaviour, cost, speed and site conditions to choose the right one.

Engineers choosing a retention system for a deep excavation or steep cut often end up comparing soil nailing with ground anchors. Both use grouted steel elements drilled into the ground, but they work in very different ways — and that determines where each makes sense.

How they work

Soil nails are passive. They are installed in a dense pattern and pick up load only as the ground begins to move slightly, creating a reinforced block of soil that behaves like a gravity wall. Ground anchors are active: each one is prestressed (tensioned) after installation and carries a large, concentrated load into stable ground behind the failure zone.

Soil nailingGround anchors
Load behaviourPassive, mobilised by small movementActive, prestressed on installation
LayoutMany closely spaced nails (1 – 2 m)Fewer, widely spaced anchors
Typical lengthShorter, around 0.6 – 1.0 × excavation heightLonger, with a free length behind failure zone
Movement controlModerate — some face deflection occursTight — suitable next to sensitive structures
CostGenerally lowerGenerally higher (stressing equipment, long tendons)
SpeedFast — simple repetitive cycleSlower — installation plus stressing and locking off

When soil nailing is the better choice

  • The ground can stand unsupported for a short height (typically 1 – 1.5 m) during excavation.
  • Stiff clays, dense sands, residual soils or weathered rock are present.
  • Some wall movement is tolerable and there are no sensitive structures immediately behind the wall.
  • Budget and programme are tight and access for large rigs is limited.

When ground anchors win

  • Very strict deformation limits apply — adjacent foundations, utilities or historic structures.
  • Very soft, loose or saturated soils where nails cannot develop adequate bond and the face will not stand.
  • Very tall excavations needing heavy, localised support.
  • Where permanent loads must be actively controlled.

Combined systems

Many projects use both: soil nails in the upper, stiffer layers and a row or two of prestressed anchors where movement matters most. A site-specific design with proper investigation will show which mix is the most economical for your site.

Related service

Soil Nailing

Top-down in-situ reinforcement of cuts, slopes and deep excavations using grouted steel nails and shotcrete facing.

Free consultation

Have a project in mind? Let's talk ground conditions.

Share your drawings or soil report and our engineers will respond with an approach, programme and quotation.